Labs
Labs is where we work with outside teams on research, integration and joint development around Software-Defined Electricity. It is a set of directions, not a catalog.
Research directions
Where we want to work with partners
These are collaboration areas, not a second product catalog. They show where our measurement, modeling, correction, engineering and manufacturing can meet another team’s work. Each card states what we build and what we measure with it. These descriptions are ours.
Thermal Management
Moving the heat that power electronics make, and removing the heat that distorted current makes.
Inverters
Correction-grade measurement and injection as an inverter control layer.
Solid-State Power
Correction stages and measurement for programmable power architectures.
Metrology & Measurement
The data-acquisition hardware behind sub-cycle power analysis.
Ways to partner
A clear working relationship from the start
Technology integration
A partner product carries a 3DFS measurement or correction layer.
Joint development
Both teams bring technology to a problem neither solves alone.
Engineering & manufacturing
Design and build support under one roof. See manufacturing capabilities.
Start here
Bring the problem, the measurements, and what the team builds.
- The problem, with the electrical conditions already recorded.
- The measurements: what was captured, at which point in the network and at what sampling resolution.
- What the team builds and where a measurement or correction layer would sit in it.